#Seadoo vts module fix upgrade
#Seadoo vts module fix full
#Seadoo vts module fix plus

The relays can be put in a small watertight box and then just drill a hole for the wires to exit and seal them up. I bought the relays at radio shack part # 275-0001 for 6.95 each so after wire and connectors you will be in less then 20 bucks. When I did mine I ran new wires from the vts motor through the back of housing by drilling a hole and sealing it up with 5200

#Seadoo vts module fix plus

If the motor doesnвЂ™t turn remove the two screws on the motor and check the armature and brushes you might get lucky by cleaning them up and save a other-wise bad vts motor and add a-little grease to the shaft ends.ДЄfter you wire up the relays the trim gauge will work if it is any good.Д¬ut the green/white and the blue/ white wires from the vts 6 pin connector (switch side) but leave the other wires un-touched so you will have a vts gauge when you are done plus the vts switches will still have the original ground. Start by checking the vts motor disconnect both wires inside box and jumper wires negative to positive on battery and motor should rotateвЂ¦ Reverse the wires to check rotation the other direction. The black box is also radio shack at 2.99 and they have the rubber grommets in a bag for 2 bucks I have put on about 150 miles on the ski I put it on in the last month using it a-lot with no issues at all.

No stop for the trim motor but if you are smart enough to look at the gauge you will have no problems. I think the Seadoo trim a waste of time but some people like it so here is what I came up with and it works like a charm. I buy ski's to re-sell and most have bad trims so this is what I came up with.

#Seadoo vts module fix full

I offer full money back guarantee if not satisfied for any reason.Just thought I would pass this on to help a few people fix there trim on the cheep.

#Seadoo vts module fix upgrade

The TrimFix is not only a Repair Solution, it is also an upgrade for your Seadoo. No special tools needed, full illustrated instructions included The Trim Fix is not only a Solution, It is an Upgrade! The Trimfix control module and gauge position sensor both mount externally of the VTS housing so the housing never even needs to be removed making the TrimFix kit even more desirable. Trimfix installation is very simple and takes about 30 min.or less to install. The TrimFix eliminates all of this by replacing the failed electronics that are in the VTS Housing and never having to remove the VTS Housing. And of course a new VTS Housing is over $300.00 and will just fail again as they always do. The original module and gauge position sensor electronics are located internally within the VTS housing and are non-serviceable, so when failure occurs, the complete VTS housing must be replaced which requires special tools, and if the repair is not done correctly, water will enter the hull and a catastrophic failure to the craft can occur. With TheTrimFix you will never again replace a bad VTS Housing to fix trim function. VTS housing failure is an extremely common occurrence, and they are too expensive to keep replacing all the time. 'Don't waste another penny on another VTS Housing!' With the TrimFix, there's no need to remove the VTS Housing at all! This kit is the SOLUTION for Seadoo trim VTS Housing failure. Item: 232869463272 Seadoo VTS Housing Trim Module fix.